NCR 7169 - TCP;IP Setting

7-143 Configuration Network
TCP/IP Setting
This section discusses configuration parameters and default values for the
TCP/IPsetting.
IP setting
Items Default value Detail
IP
Address
192.168.1.1
Sets the printer IP Address.
Note: To manually enter the IP address, disable DHCP.
Subnet
Mask
255.255.255.0
Sets the printer Subnet Mask.
Note: To manually enter the Subnet Mask address,
disable DHCP.
Default
Gateway
0.0.0.0
Sets the Printer Default Gateway.
Note: To manually enter the Default Gateway address,
disable DHCP.
DHCP Enabled Specifies how the IP address is assigned.
• Enabled—IP address is automatically assigned from
the server.
• Disabled—IP address is manually entered in the
fields.
DHCP
Request
IP
Address
0.0.0.0
Sets requesting specific IP address to DHCP server.
Note: If the DHCP Request IP Address is set to 0.0.0.0,
printer IP address is automatically assigned.
Note: IP addresses that cannot be set with Ethernet model printer are the following:
• 255.255.255.255 (Broad cast address)
• Local loopback address
• 127.***.***.***—this is the IP Address to send to oneself and *** is any
value from 0 to 255.