NCR 7360-K071 - Installing the Tri-Light;Lane Light Assembly

To Next Page

To Previous Page

Standard Tri–Light/Lane Light Assembly with Lane Light

Label (Self Checkout)

Installing the Tri–Light/Lane Light Assembly

Note: To install a Tri–Light/Lane Light with Camera Assembly, refer to 7360-K066 Tri-

Light with Camera Assembly Kit Instructions for more information.

To install the Tri–Light/Lane Light assembly, follow these steps:

1. Remove the existing Tri–Light/Lane Light assembly, if necessary. For more

information, refer to Removing Tri–Light/Lane Light Assembly on page4.

2. Connect the Tri–Light/Lane Light assembly cables with the cable extender in the

pole.

3. Orient the Trilight/Lane Light assembly so that the Lane Light faces the front of the

unit.