NCR 74 OFX (7874) - Terminal Coupon Select 2; Voice Messages-Enable;Disable

Chapter 5: Programming 5-93
Terminal Coupon Select 2
1. ScantheProgramModetag.
2.
ScantheHex3andHexDtagstoselectthisparameter.
3.
ScanaHex0throughHex7tagtosetaCouponSelect2parameter:
Coupon Select 2 Parameter Disable Enable
CouponandP5or128optional(EAN‐99) Hex0 Hex1
Couponand128mandatory(EAN‐99) Hex2 Hex3
MarkdownTone Hex4 Hex5
EarlyToneforOptionalAdd–On Hex6 Hex7
4. ScantheSaveandResettagtosavetheprogram.
Note: Repeatsteps1through4tosettheotheroption,ifneeded.
5.
ScanProgramMode,Hex1,Hex7,HexF,Hex0,andSaveandResettagsto
completetheprogrammingfunction.
Note: ScanningtheDefaulttagresetsalloptions.
Voice Messages—Enable/Disable
TheRealScan74usesvoicemessagesfordiagnostics,andclerkmessages.Ifvoice
messagesareenabled,theyareheardattheappropriatetime;iftheyaredisabled,the
beeptonesareheardinstead.Toenableordisablevoicemessages,scanthefollowing
sequenceofprogrammingtags.Thesetagsmustbethe
firsttagsscannedafter
applyingpowertotheunit.
All Voice Messages Off/On
1.
ProgramMode
2.
Hex3
3.
Hex3
4.
HexD
5.
SaveandReset
Clerk Messages On
1.
ProgramMode
2.
Hex3
3.
Hex3
4.
Hex1
5.
SaveandReset