NCR 74 OFX (7874) - NCR Realscan 2357 and Hand-Held Products (Honeywell) Type Hand-Held Scanner; Programming Hand-Held Products Scanner if Connected through the Auxiliary RS232 Port

3-42 Chapter 3: Installation
NCR RealScan 2357 and Hand-Held Products (Honeywell) Type Hand-Held
Scanner
TheseinstructionsapplytoallHand‐HeldProductsscannersand7837models(except
the7837‐1000specifically),includin gthe3800gand4600seriesimagers.
WhenconnectingaRealScan2357Hand‐HeldScanner,certainprogrammingoptions
mustbesetonboththeRealScan74andtheHandheldScanner.Theseoptionsare

givenasfollows.
Programming Hand-Held Products Scanner if Connected through the Auxiliary
RS232 Port
IftheRealScan2357Hand‐HeldScanner(anymodel)isconnectedtotheRealScan74
throughtheauxiliaryRS232port,programtheHand‐HeldProductsScannerby
scanningthefollowingbarcodesinorder.IfatriplebeepisemittedfromtheHand‐
Heldscanner,startoverwiththefirstbar
code.
FACTORY DEFAULT


Prefixes / Code 39 - a, Code 128 - f, Code I 2of 5 - b

Default Data Format



