NCR 7454 - Routing the Cables

2-4 Chapter 2: Hardware Installation
Routing the Cables
The7454hasthreeplacestosecurecablestothebaseoftheunitby
usingacabletiewrap.Removethepowersupplycoverorcustomer
displayfromthebaseoftheunit,twothumbscrewsonbottomrear,
anduseatiewraptosecuretheEthernetcableto
oneoftheprovided
moldedcabletieholdersonthebase.Thisshouldprovidesufficient
strainrelieftopreventthecablefrombecomingtightanddamagingthe
connectorontheProcessorBoard.
TheperipheralcablesarerouteddownthroughtheMountAssembly
andouttherearoftheunit.
16413a
Bottom View
