NCR 7454 - Wall Mounting a Tilt Mount

Chapter 2: Hardware Installation 2-25
Wall Mounting a Tilt Mount
ToinstalltheTiltMounton aflatverticalsurface,usetheK533Wall
MountBracketKit.
1. SecuretheWallPlatetothewallwithlagscrews(4)intothestuds
orwithhardwareofsimilarstrength.Therecommendedviewing
heightfortheterminalis1.2m(48ʺ)from
thefloor.
16400
Wall Plate
Wall Mount Adapter Plate
Release Lever

2. InstalltheWallMountAdapterPlatetothebottomoftheterminal
withscrews(4).
3. InstalltheterminaltotheWallPlate.ThebottomoftheWallMount
AdapterPlatehasslotsthatmatetolockingtabsontheWallPlate.
4. LatchtheReleaseLever.