NCR 7454 - Chapter 3: Setup; BIOS Setup Introduction; Accessing BIOS Setup

Chapter 3: Setup 3-3
Note: Ifyouarenotusinganexternalkeyboard,youcantouchthe
menucontrolsatthebottomofthescreen.Ifyouencounterdifficulty
doingthis,recalibratethescreen.
Restoring Factory Settings
Toautomaticallyresetallvaluestotheirdefaultsettingsforthecurrent
screen,pressF9.TheterminalwillautomaticallyloadBIOSdefault
CMOSvaluesforbootup.
ToresetallBIOSsettingstotheirdefaultsettingsgototheExitmenu,
pressF9,selecteitherSaveChanges&Exitor
SaveChanges,andpress
Enter.
RefertotheBIOSDefaultCMOSValuessectionlaterinthischapterfor
thepre‐installedSetupdefaults.