Chapter 3: Setup 3-37
I/O Device Configuration
Move the cursor to the I/O Device Configuration option, press Enter and
the following sub-menu appears.
I/O Device Configuration Item Specific Help
Serial port A: [Auto]
Scanner Power: [Auto]
Serial port B: [Auto]
Parallel port: [Auto]
Mode: [Bi-directional]
Fdc On Lpt: [Disabled]
Floppy disk controller: [Disabled]
Serial port C: [Enabled]
Mode: [Normal]
Base I/O Address: [220]
Interrupt: [IRQ 11]
Scanner Power: [Auto]
Serial port D: [Enabled]
Base I/O Address: [228]
Serial Port x
This option configures the serial ports (A/B/C/D).
1. Move the cursor to the Serial port x: option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Disabled – no configuration
• Enabled – user configuration
• Auto – BIOS or OS chooses configuration
• OS Controlled – (displayed when controlled by OS)
MainExit
PhoenixBIOS Setup Utility
Disabled
Enabled
Auto
To Next Page
Loading...
