B-24 Appendix B: Feature Kits
Setting the BIOS Parameter
1. Power up the terminal.
2. Enter the PhoenixBIOS Setup Utility (refer to the Setup chapter).
3. Select the
Advanced menu.
4. Select
I/O Device Configuration.
5. Verify that
Disk-On-Chip Address: is set to CE00-CFFF.
Installing the Driver
1. In Windows Explorer, switch to the following folder.
c:\install\drivers\dskonchp
2. Right-click on trueffs.ini and select Install.
3. Reboot the terminal. The Flash Disk will install as the next logical
drive.
To Next Page
Loading...
