Chapter 7: Programming 7-71
Result: The scanner sounds the Good Read tone one
time to indicate that the scanner accepted the multi-
symbol label. If the multi-symbol label is already in the
scanner's memory, the scanner then beeps twice for a 2-
symbol label or three times for a 3-symbol label. A long,
loud tone (error tone) indicates that the scanner's
memory already has the maximum of five multi-symbol
label combinations.
5.
To program more labels, repeat Options C or D until a maximum of
5 label types (in any combination) have been scanned into memory.
6.
Scan the Save and Reset tag to save the multi-symbol
programming. The scanner should go through a sequence similar
to a power up sequence.
7.
Remove power from the NCR 7870 and connect the
communications cable.
To Next Page
Loading...
