KIT DESCRIPTIONS
Various kits are available to enhance the capabilities or change the
hardware configuration of the NCR DECISION MATE V. Many of
these kits can be plugged directly into the I/O bus by the user:
others require installation by a service engineer.
Integrated Fixed Disk
This kit (K012) provides for the integration of a fixed (Winchester)
disk drive. The kit includes the necessary changes for the power
supply. When installed, the system has one fixed disk drive
(capacity 10M bytes) and one flexible disk drive (capacity 320/
360K bytes).
Second Integrated Flexible Disk
These kits upgrade an NCR DECISION MATE V from a system
with one flexible disk drive to a system with two flexible disk
drives. Kit K018 is for systems produced in the DIN color scheme,
kit K019 is for systems in the Corporate Appearance Plan (CAP)
color scheme.
Memory Expansion Modules
These kits (K200, 202, and 208) can be installed, by the user,
directly into slot 1 of the I/O bus. It is only possible to install
one kit into a system. The kits provide the following memory
capacities:
• K200 increases memory capacity from 64K to 128 K bytes
• K202 increases memory capacity from 64K to 256Kbytes
• K208 increases memory capacity from 64K to 512Kbytes
Centronics Peripheral Adapter
This kit (K210) can be installed, by the user, directly into the
I/O bus (slots 2 to 6). The kit includes a 2 metre (6.6 ft.) cable
complete with plug, that allows connection to a Centronics com
patible (parallel input) printer.
RS-232-C (Communications) Peripheral Adapter
This kit (K211) can be installed, by the user, directly into the
I/O bus (slots 2 to 6). The kit includes a 2 metre (6.6 ft.) cable
complete with plug, that allows connection to an RS-232-C com
patible (serial) communications device.
1-4
To Next Page
Loading...