SYSTEM TECHNICAL MANU AL
SYSTEM OVERVIEW
RS-232-C (Printer) Peripheral Adapter
This kit (K212) is similar to K211, but is used for the connection
of RS-232-C compatible (serial) printers.
RS-232-C (Plotter) Peripheral Adapter
This kit (K213) is used for the connection of a compatible plotter
(e.g. NCR 5403) to the NCR DECISION MATE V.
Blank Interface Adapters
These kits (K214, 217, and 218) comprise a housing, an I/O
bus connector, and a blank printed circuit board. They provide
the necessary hardware to help the system integrator to develop
custom interfaces or adapters.
• K214 provides hardware for one adapter
• K217 provides hardware for five adapters
• K218 provides hardware for 25 adapters
Integrated Modem
This kit (K219) can be installed, by the user, directly into the
I/O bus (slots 2 to 6). It is designed to support the following
modems:
® Bell 103 (300 baud)
® Bell 2035 (1200 baud)
Built into the modem housing are two sockets for the connec
tion of standard telephone type plugs: a cable is included for the
connection of a telephone.
Diagnostic Module
This module (K220) can be installed directly into slot 7 of the I/O
bus, and is intended for service engineers and other persons inter
ested in diagnosing problems. The module tests the computer and
provides information on failures. It also monitors the logical
voltages (+5 and +12 Vdc) and indicates whether the voltages are
within or outside the specified limits. For a full description, refer
to the NCR DECISION MATE V Service Manual.
8/1 6-Bit Processor
Kit K231 can be installed, by the user, directly into slot 7 of the
I/O bus. It converts the NCR DECISION MATE V from an 8-bit
system to a dual 8/16-bit system that is capable of using either
8-bit or 16-bit operating system and application software.
1-5
To Next Page
Loading...