NCR FastLane SelfServ 7358-K112 - Routing Cables for No-Bag Unit

2-Bag Bagwell Upgrade 29
Routing Cables
To route cables when installing a new Bagwell, follow these steps:
Note: If a new Bagwell is installed to a No-Bag unit, refer to Routing Cables for No-Bag
unit on page32.
Note: Use the new pre-installed USB Power Cable only when installing a new Bagwell
to a No-Bag unit. If not, reuse the existing USB Power Cable of the previous Bagwell.
1. Retrieve the USBPower Cable from the Core and route to the Scale Controller
through the smaller opening of the Bagwell frame as shown in the image below.