NCR iTRAN 180es - Repairing a Torn Encoder Ribbon

Replacing Parts
Low-Speed Encoder
4-32 NCR iTRAN 180es/300es/600 Operator’s Guide
Repairing a Torn Encoder
Ribbon
4
If the encoder ribbon ever breaks, your workstation stops moving documents
and displays a message on the workstation screen. Go get the following
supplies:
• a pair of scissors
• a roll of transparent adhesive tape
Swing the hinged encoder door up to the right until it stays open. Then follow
these steps to repair the ribbon.
1 Push forward on the take-up spool to wind the used ribbon on to it.
2 Lift out the roll of used ribbon on the take-up spool and set it aside.
3 Push the green latch to the right, then up, to unlatch the print head.
4 Tip the track end of the print head down.
take-up spool
green latch
print-head
C00619