Replacing Parts
What Parts Should You Replace When?
4-2 NCR iTRAN 180es/300es/600 Operator’s Guide
What Parts Should You Replace When?
4
The maintenance schedule supplied with this guide shows which parts of
your transport you must replace and how often you must replace each of
them.
• For supplies that get used up, such as the encoder ribbon, the transport
tells you when you need to replace them. The transport stops running,
and a specific message appears on screen.
• For parts that wear out in normal use, such as the plastic strips on the
pockets, the transport will not give you a message, and you have to rely
on the chart alone.
Check the chart regularly to make sure you are replacing parts as required.
Note: For the part numbers to use when ordering supplies, see Chapter 5,
“Ordering Supplies”
Part When to Replace
High Performance Hopper picker
belt
Every 1 000 000 documents or if
documents do not feed properly
High Performance Hopper advance
tire
Every 1 000 000 documents or if
documents do not feed properly
High Performance Hopper retard
belt
Every 1 000 000 documents or if
documents do not feed properly
Merge Hopper wiper feeder belts Every 1 000 000 documents or if
documents do not feed properly
Merge Hopper wiper Every 500 000 documents or if
documents do not feed properly
Encoder ribbon When you get a message
Graphical endorser ink cartridge When you get a message
Pocket mylar plastic strips Check after 5 000 000 documents,
replace after 2 000 000
To Next Page
Loading...