Replacing Parts
High Performance Hopper
NCR iTRAN 180es/300es/600 Operator’s Guide 4-5
3 Turn the black retard release knob clockwise and hold it to loosen the
front part of the belt, then remove the front part of the belt.
4 Replace the old belt with a new belt, following the diagram on the
module.
Note: Make sure that the belt is positioned properly between the top and
bottom lips of each of the pulleys.
5 Replace the cover
Replacing the Advance Tire
4
This procedure should be done each time your transport has processed
1 000 000 documents.
1 Lift up on the Hopper front cover and remove.
To Next Page
Loading...