Replacing Parts
High Performance Hopper
NCR iTRAN 180es/300es/600 Operator’s Guide 4-7
4 Remove the feeder belt from the small pulley. To do this, pull up gently
on the belt, turning the pulley if necessary to free the belt.
5 Remove the belt from the large pulley on the left, working as described
in step 4 (this is easier to do if you hold the wiper lever back). Throw
this belt away.
6 Replace the feeder belt as follows:
• Loop one end of the new belt over the large pulley, then push the
belt down around the pulley until the belt is properly seated between
the top and bottom rims. (Turning the pulley as you work may help
you get the belt seated properly.)
• Install the other end of the belt on the small pulley. Turn the pulleys
by hand to be sure the belt moves smoothly.
7 With one hand, pick up the new wiper by its handle.
8 With the other hand, push back on the wiper lever and hold it open.
To Next Page
Loading...