Replacing Parts
High Performance Hopper
4-8 NCR iTRAN 180es/300es/600 Operator’s Guide
9 Insert the bottom of the wiper into the hole in the wiper lever. Push the
wiper all the way down.
10 Let go of the wiper lever. The new wiper is now in place.
11 Replace all the removed the cabinetry (be sure to push it all the way
down).
12 If you removed any documents from the hopper, put them back in the
proper order.
13 Close the receipt cover.
14 Press the Paper Feed button on the operator panel to advance the paper.
The cover must be closed. To ensure print quality and the proper alignment
of the paper, advance about 30 cm (12 inches) of paper.
To Next Page
Loading...