NCR P1235 - 8 Additional Monitor Installation Instructions

NCR P1235 e*SmartClock Installation Guide, Ver. 1.1
US-IT Restaurant Architecture Team
Page 24 of 37 12/6/16
8. Additional Monitor Installation Instructions
Store managers are required to have direct view of e*SmartClock to observe timeclock. Additional monitor allows
them to have duplicated e*SmartClock display if they have any challenges to view e*SmartClock directly
This section provides instructions to duplicate NCR P1235 e*SmartClock Display on second monitor to enable Store
manager with duplicated e*SmartClock display, this is optional step based on the need and is not
mandatory/required for e*SmartClock functionality.
In order to install an additional monitor to duplicate the NCR P1235 e*SmartClock display, you will need below
components. This are additional components which are not shipped with the e*SmartClock.
1. Display port to VGA adaptor – 1 unit
2. VGA cable – 1 unit
3. Monitor with power cable – 1 unit
Step Step Description Pictures
1
NCR P1235
has display port which can
be utilized to duplicate the display on
the second monitor.
2
Display port to VGA cable adapter is
needed to connect to the display port
on the NCR P1235 with the VGA port
on the cable that would connect to the
second monitor.
Picture showing the Display port to
VGA adapter connected to the display
port on the NCR P1235.
3
Display port to VGA adapter cable’s
(Female) port should attach to VGA
port (Male) on the cable connecting to
second monitor as shown in picture.