Hardware Installation 2-17
Connecting to a Network
Most business configurations require the PX10 system to connect to a network.
Connecting to a network enables communicating with other systems and devices also on
the network. Depending on business configurations, connecting to a network may allow
connection to the Internet.
To connect the PX10 terminal to a network, plug the 10/100/1000 Ethernet cable into the
port labeled LAN on the bottom panel. The other end of the 10/100/1000 Ethernet cable
should be connected into the network hub.
Note: Consult with your business Information Technology (IT) representative to
determine the available connection, and to locate the network hub.
To Next Page
Loading...
