2-18 Hardware Installation
Starting Up the PX10 Terminal
To run the operating system and to access software and data, start up the PX10
platform. To start up the PX10, complete the following procedure:
1. Plug the power cord into an electrical outlet.
2. Press the Power Button on the Front Base of the terminal. The unit can later be
configured by software to power on without pressing the switch.
The system installs the system devices, configures system settings, and then reboots
to continue setup. Complete the System Setup. This varies from OS to OS, but the
following initial setup procedures are typical:
• Starting Windows
• Preparing the computer for the first time
• Checking video performance
3.
Accept the License Terms Agreement.
Note: Depending on the installed operating system and the selected settings, the
amount of time it takes to boot up may vary.
To Next Page
Loading...
