NCR RealPOS 40 - RS-232 Installation

2-8 Chapter 2: Hardware Installation
RS-232 Installation
1. ConnecttheRS‐232PrinterInterfaceCabletotheRS‐232connectorontheprinter
andtoanon‐poweredRS‐232connectorontheterminal.
Note: ThefactorydefaultsettingfortheRS‐232portsispowered.Seethe
Appendix:PoweredSerialPortSettings.
2. ConnectthePoweredUSBPrinterInt
erfaceCabletothePowerConnectoronthe
printerandtothe24VPoweredUSBConnectorontheterminal.
28577
A
B
Power
RS-232
24V USB
497-0441156 - 1m
(1432-C092-0010)
497-0441157 - 4 m
(1432-C092-0040)
RS-232
