NCR RealPOS 40 - Installing a Secondary Display (Dual Display)

2-22 Chapter 2: Hardware Installation
Installing a Secondary Display (Dual Display)
The7600MotherboardusesanintegratedvideocontrollerwiththeIntel945GSEGMCH
chipset.ThiscontrollerprovidesaMonitorport(VGA)andaDigitalDisplayport(DVI)on
themotherboardconnectorrow.Thesetwoportsprovideasingledisplaymode(DVIor
VGA)oradualdisplaymode(DVIandVGA).Dualdispla
ymodecanbeaclone(same
videodatadisplayedonbothdisplays)oranextendeddesktop(thedesktopspansacross
bothdisplays).
ThedualmodeisconfiguredusingtheIntel®GraphicsMediaAcceleratorcontrolpanel.

1. Powerdownthesystem.
2. Connectthesecondarydisplay.
Note: Bothdisplaysmustbeconnectedtothe7600beforepoweringupthe
system.
3. Applypowertothesystem.
4. RightclicktheDesktopandthenselect
Graphics Propertiesfromthemenutostart
thecontrolpanel.Thefollowingscreenindicatesthesystemwaspreviouslyconfigured
withasingleVGAdisplay.


