NCR RealPOS 40 - Chapter 3: Setup; Entering Setup; How to Select Menu Options; Restoring Factory Settings

3
Chapter 3: Setup

Entering Setup
1. ConnectanalphanumericUSBkeyboardtotheterminal.
2. Applypowertotheterminal.
3. WhenyouseetheNCRlogodisplayedpress[Del].
How to Select Menu Options
Thefollowingkeyboardcontrolsareusedtoselectthevariousmenuoptionsandto
makechangestotheirvalues.
 Usethearrowkeystoselect(highlight)optionsandmenuscreens.
 Usethe[Enter]keytoselectasubmenu.
 Usethe[+]and[-]keystochangefieldvalues.
 Toviewhelpinformationonthepossibleselectio
nsforthehighlighteditem,press
[F1].
 Tosavethechanges,movethecursortotheExitMenu,selecteitherSaveChanges
&ExitorSaveChanges,andpress[Enter].
Restoring Factory Settings
Toresetallvaluestotheirdefaultsettingsforthecurrentscreen,press[F9]andthen
[Enter]whentheconfirmationmessageisdisplayed.Theterminalautomatically
loadstheBIOSdefaultvalues.ToresetallBIOSsettingstotheirdefaultsettingsgoto
theExitmenu,pressF9,selecteitherSaveChanges&ExitorSaveChanges,andpress
[Enter].
Note: The760
0Motherboardisusedonotherproductsandhasajumperthatisused
toselecttheproperBIOSdefaults.IftheMotherboardisreplacedbesurethisjumper
issettotheRSDsetting.
SeetheBIOSDefaultSettingssectionslaterinthi
schapterforthepre‐installedSetup
defaults.