NCR RealPOS 40 - BIOS Default Values

3-2 Chapter 3: Setup
BIOS Default Values
NCRBIOSVersion:1.1.8.0
Main Menu
System Time
(variable)
System Date
(variable)
Advanced Menu
CPU Configuration

 MaxCPUIDValueLimit  [Disabled]
 Execute‐Dis ableBitCompatibility [Enabled]
 Intel(R)SpeedStep(tm)tech [Enabled]
 Intel(R)C‐STATEtech [Enabled]
 EnhancedC‐States [Enabled]
IDE Configuration

 ATA/IDEConfiguration [Enhanced]
ConfigureSATA#1as [AHCI]
 SATA0 [HardDisk]
Type [Auto]
LBA/LargeMode [Auto]
Block(Multi‐SectorTransfer) [Auto]
PIOMode [Auto]
DMAMode [Auto]
S.M.A.R.T. [Auto]
32BitDataTransfer [Enabled]
 SATA1 [NotDetected]
Type [Auto]
LBA/LargeMode [Auto]
Block(Multi‐SectorTransfer) [Auto]
PIOMode [Auto]