NCR RealPOS 70 - DVI)

7-6 Chapter 7: Installing a Secondary (Dual) Display
Extended Desktop Dual Display Mode Setup (DVI and DVI)
ThismodeisaccomplishedusingaPCIDVIvideocard,suchasthe
MatroxMillennium.
Note: TheBIOSvideosettingsshouldbechangedbeforeinstallingthe
PCIcardintotheterminal.
1. VerifythatthePrimaryDVIdisplayisconnectedtothe
MotherboardandsetupproperlyinWindows(seeSingle
Display
Setupabove).
2. Applypowertotheterminal.
3. WhenyouseetheNCRlogodisplayedpress[Del]toentertheBIOS
SetupUtility.
a. SelectChipset
→ Intel Montara-GML NorthBridge.
b. ChangePrimary Video DevicefromAutotoInternal.
c. Press[F10]toSaveandExit,then[Enter]toconfirm.
d. Pressthepowerbuttonastheterminalboots(bootinginto
Windowsisnotrequiredatthistime).
4. InstalltheDVIPCIcard.
5. Installthevideodriverfor
thePCIcard(seehttp://www.ncr.com/
Support).
6. UsetheIntelGraphicsControlPaneltoadjustthesettingsofthe
MotherboardDVIdisplay.
7. UseWindowsDisplayPropertiestoenableExtendedDesktopandto
adjusttheDVIPCIsettings.
Note: TheMotherboardDVIportshouldbethePrimaryDisplayin
Windows.