NCR RealPOS 7199 Thermal Receipt Station Printer 21
Using the Printer
To use the printer, follow these steps:
1. Connect the power supply to the printer and turn on the power source. The printer
goes through a self–test routine to ensure everything is working properly, and then
it “beeps.” After the printer has completed its “startup” cycle, it is ready to receive
data. If the LED blinks, or the host computer indicates that there is a problem, refer
to Troubleshooting Problems on page27 for more information.
2. To perform a Configuration check (optional), reset the printer while holding the
Paper Feed button, or open the receipt door and, while pressing the Paper Feed
button, close the receipt door. Let go of the Paper Feed button when the printing
begins.
Note: The printer receives power when the power supply is on even if the printer is
offline. To completely remove power, unplug the power supply from the outlet, or turn
the POS terminal off.
To Next Page
Loading...
