2-42 Installing the Terminal
Installation Summary
• Remove the terminal from the shipping packaging and verify the hardware
configuration.
• Connect the peripheral and communication cables.
• Attach the Power Cord to the system and to an AC power source.
• After power is applied to the terminal the Power-up self-tests run to verify basic
functionality.
• ROM-based setup should be used to configure network options. Full configuration
depends upon the system server and the management web site.
Installation Restrictions
"Before installing the terminal, read and follow the guidelines in the NCR RealPOS 72XRT
Site Preparation Guide (B005 0000 2229) and the NCR Workstation and Peripheral AC Wiring
Guide (BST0 2115 53).
• Install the terminal near an electrical outlet that is easily accessible. Use the power
cord as a power-disconnect device.
• Do not permit any object to rest on the power cord. Do not locate the terminal
where the power cord can be walked on.
• Use a grounding strap or touch a grounded metal object to discharge any static
electricity from your body before servicing the terminal.
• If the power cord is replaced, it must be replaced with the same type of cord.
• Do not route the power cord through openings with sharp edges.
Warning: This unit contains hazardous voltages and should only be serviced by
qualified service personnel.
Warning: DO NOT connect or disconnect the transaction printer while the terminal
is connected to AC power. This can result in system or printer damage.
Warning: DO NOT connect or disconnect any serial peripherals while the terminal
is connected to AC power. This can result in system or printer damage.
To Next Page
Loading...
