7 - 42
PDF417, continued
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the back cover, scan the Minimum or Maximum bar
code, scan the correct digits, and Save again.
Show GLI Blocks
Turning Show GLI Blocks
On
causes GLI commands to be issued where located
within their encoded data sequences. When on, the “\” is used as an escape
character and natural occurrences of “\” in data are replaced by “\\”.
Default = Off
.
Scan Diagnostics
When Scan Diagnostics is turned on, the scanner sends a report instead of the
decoded message. Your terminal displays the diagnostic information first, then
the data from the scanned code.
Default = Off
.
Minimum (Default =1)
Maximum (Default =2750)
On
* Off
On
* Off
To Next Page
Loading...
