12 - 9
Secondary Interface Selections
Wand Emulation Connection
Same Code Format 2IFTYP0
*Code 39 Format 2IFTYP1
Secondary RS-232 Connection RS-232 Interface 2IFTYP2
Secondary Non Decoded Out-
put Laser Emulation
Non Decoded Output 2IFTYP3
Non Decoded Output Laser
Emulation Transmission Rate
*36 HLCSPD0
100 HLCSPD1
Non Decoded Output Laser
Emulation Polarity
Black High HLCPOL0
*White High HLCPOL1
Non Decoded Output Laser
Emulation Idle
Low HLCIDL0
*High HLCIDL1
Disabling the Secondary Inter-
face
*Disable 2IF_EN0
Enable 2IF_EN1
Secondary Trigger Mode
*Manual Trigger 2IFTRG0
Automatic Trigger 2IFTRG1
Manual Trigger, Low Power 2IFTRG2
Low Power Time Out 2IFLPT
Symbologies
All Symbologies
All Symbologies Off ALLENA0
All Symbologies On ALLENA1
Codabar
Default All Codabar
Settings
CBRDFT
Codabar
Off CBRENA0
*On CBRENA1
Codabar Start/Stop Char.
*Don’t Transmit CBRSSX0
Transmit CBRSSX1
Codabar Check Char.
*No Check Char. CBRCK20
Validate Modulo 16, But
Don’t Transmit
CBRCK23
Validate Modulo 16,
and Transmit
CBRCK24
Codabar Concatatenation
Off CBRCCT0
*On CBRCCT1
Require CBRCCT2
Selection
Setting
* Indicates default setting
Serial Command
# Indicates a numeric entry
To Next Page
Loading...
