2 - 2
Terminal ID
If your interface is not a standard PC AT, refer to "Supported Terminals" on
page 2-3 through page 2-4, and locate the Terminal ID number for your PC.
Scan the Terminal ID bar code below, then scan the numeric bar code(s) on the
inside back cover of this manual to program the scanner for your terminal ID.
Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the inside back cover, then Save. If you
make an error while scanning the digits (before scanning Save), scan the
Discard code on the back cover, scan the Terminal ID bar code, scan the
digits, and the Save code again.
Note: After scanning one of these codes, you must power cycle your computer.
The RealScan 7837 High-Performance Scanner can interface to most retail
terminals available on the market today. Contact NCR for terminals not in the
following list.
Terminal ID
Save
To Next Page
Loading...
