2 - 7
Emulate External Keyboard
should be scanned if you do not have an external
keyboard (IBM AT or equivalent). To connect the scanner to a laptop, it may be
necessary to use the Automatic Direct Connect selection on page 2-8 in
conjunction with the bar code below.
Note: Note:After scanning the Emulate External Keyboard bar code, you must
power cycle your computer.
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and
Turbo Mode.
Control + ASCII Mode On:
The scanner sends key combinations for ASCII
control characters for values 00-1F. Refer to page 9-1 for CTRL+ ASCII
Values.
Default = Off
Turbo Mode:
The scanner sends characters to an IBM AT terminal faster. (For
use with IBM AT only.) If the terminal drops characters, do not use Turbo Mode.
Default = Off
Emulate External Keyboard
Control + ASCII Mode On
* Control + ASCII Mode Off
Turbo Mode On
* Turbo Mode Off
To Next Page
Loading...
