4 - 8
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the back cover, scan the Intercharacter Delay bar code,
scan the correct digits, and Save again.
To remove this delay, scan the Intercharacter Delay bar code, then set the num-
ber of steps to 00. Scan the SAVE bar code from the inside back cover.
User Specified Intercharacter Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed after the trans-
mission of a particular character of scanned data. You can program up to 99
steps (of 5 ms each) to follow the character you specify. Scan the Delay Length
bar code below, then the number of steps for the delay, and the SAVE bar code
from the inside back cover.
Next, scan the Character to Trigger Delay bar code, then the 2 digit hex value
for the ASCII character that will trigger the delay (refer to the Decimal to Hex to
ASCII conversion chart on page 4-5).
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the inside back cover, scan the Character to Trigger
Delay bar code, scan the correct digits, and Save again
.
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay
Delay Length
Character to Trigger Delay
To Next Page
Loading...
