6 - 3
Non Decoded Output Laser Emulation Polarity
The Polarity can be sent as standard with white bars high, or reversed with
black bars high.
Default = White High.
Non Decoded Laser Emulation Idle
The idle describes the state of the scanner when no data is being transmitted.
When in Non Decoded mode, you must set the scanner’s idle state to match the
idle state for the device to which the scanner is connected.
Default = High.
Disabling the Secondary Interface
You can temporarily disable the secondary interface, but still retain the second-
ary interface settings in the scanner’s memory by scanning the Disable bar code
below. To re-enable the secondary interface, scan the Enable bar code.
Default =Disable
.
* White High
Black High
Low
* High
* Disable
Enable
To Next Page
Loading...
