User Guide
41
www.nec-computers.com
Caution
■ The removed rail assemblies are to be installed on the inner
rails later.
■ Do not catch your fingers in the levers or rails.
Installing the rail assemblies
1. Insert the square projection of the rail assembly into the angle hole on the 19-
inch rack until it is locks into place.
The figure below shows the right side (front) of the rack. Install the rail
assemblies to the right side (rear), and left side (front and rear) of the rack in
the same procedure.
Figure 14: Installing the Rail Assembly (Right Side Shown)
Make sure that the rail assembly is installed at the same level as the other slide
rail assembly already installed.
Note: There may be some backlashes in the front and rear,
however, it is not a deficiency.
To Next Page
Loading...