NEC Pinwriter P2000/P2X - Normal Setting Mode - Description of Settings

18 Section 3 Control Panel
Normal Setting Mode - Description of Memory Switch Settings
The normal setting mode has six groups of memory switch settings:
# Group A: Print mode a Group D: Interface
0 Group B: Format 0 Group E: Horizontal alignment
Q Group C: Paper handling
n Group F: Print & reset settings
Table 3-2 describes the switch functins in each group. Values put in the brackets
“[ 1” denote the factory default setting. See the menu three on page 15 for selectable
entries in each mode.
Table 3-2 Switch Functions
Item Function
Group A: Print Mode
\
1. Language char. sets
2. Shape of zero
3. Quiet mode
Selects the tanguage character set default. [U.S.A.]
Selects the shape of zero. [0]
Selects the quiet mode, in which the printer prfnts at a reduced
speed and noise level. [disable]
4. Graphics print direction Selects the’graphics print direction defaut. [unidirectional]
5. Hex dump mode
Selects or cancels the hex dump mode. [disable]
Group B: Format
1. Form feed length
2. Skip over perforation
3. 0 margin emulation
4. CR function
5. LF function
Selects the form feed length defauft for continuous paper in
inches. P2000: [ll in.] Pw: [12 in.]
Selects or cancels I inch skip-over perforation at power-up. [no skip]
Selects or cancels 0 margin emulation. [disable]
Selects CR code (ODh) function.
P2000: [CR only] P2X: [CR W/O PRINTOUT]
Selects LF code (OAh) function. [CR t LF]
Group C: Paper Handling
1. Top margin (cut sheet guide)
2. Top margin (push tractor)
3. centre pos.
4. S/F left margin
Selects the top margin of the cut sheet guide in inches. [0.93 in.]
Diice from the top edge of the paper to the middle of the first
print fine.
Selects the top margin of the push tractor in inches. [0.93 in.]
Distance from the top edge of the paper to the middle of the first
print line.
Selects the centering position of the cut sheet. [column 421
Selects the left margin in a unit of column when the sheet feeder is
installed. [l]