Manufacturer’s Instructions and User’s Responsibility to Prevent Radio
Frequency Interference
Manufacturer’s
Instructions
The
user
must observe the followinp precautions in installing and operating this device:
1.
Operate the equipment in
strict
accordance with the manufacturer’s instructions
for the
model.
2.
Plug the unit into a properly-grounded wall outlet and use the power
cord
supplied
with the unit, unmodified.
3.
4.
Always operate the unit with the factory-installed cover on the unit.
Make no modification to the equipment which would
cause
radio frequency
interference.
5.
Maintain the equipment in a satisfactory state of repair.
6.
Use a shielded and properly-grounded I/O
cable
to prevent radio frequency
interference.
User’s Responsibility
The
user
is ultimately responsible for correcting
problems
that arise from harmful radio-
frequency emissions from equipment under the user’s control. If this equipment does
cause
interference to radio or television reception (which
can
be determined by turning
the equipment off and on), the user is encouraged to try to
correct
the interference by one
of the followinp measures. All of these responsibilities and
any
others not mentioned are
exclusively at the expense of the
user.
1.
Change in orientation of the receiving device antenna.
2.
Change in orientation of the equipment.
3. Change in location of equipment.
4.
Change in equipment power
source.
To Next Page
Loading...