Section
4 Paper Loading 29
0
8
0
@
0
0
Q
Q
0
From the rear of the printer, insert continuous
Papers
by using the markings
embossed on the rear of the Printer cover.
Turn the Paper feed
dial
to pull
up
the Paper to the height of the tractors.
Set the Paper selection lever to the front position.
Pu11
the sheet guide upward and then turn it toward the rear.
Unlack the left and right tmctors by flipping their
leck
levers up.
Open the left and right tractor covers.
Set the left tractor so that its feed pins
ahgn
with the holes on the left side of the
Paper.
Close and leck the left tractor into Position by flipping the
leck
lever
down.
Set the right tractor so that its feed pins
ahgn
with the holes on the right side of
the
Paper.
Close and leck the right tractor.
,
NOTE: Fit
the
Paper
snugiy
between the tractors but do not
stretch
the
Paper
feed holes.
Close the top cover, leaning it over the tractor.
Turn on the
Printer
power.
The Printer is now ready to receive print commands from your Computer.
NOTE: When the
Printer
is out of
Paper
during printing and the SELECT light is blinking,
insert continuous
Papers
and press MODE to resume printing.
To Next Page
Loading...