30 Section 4 PaDer Loadina
Loading for
Bottom
Feed
You can use the printer’s bottom feed feature to print continuous papers.
You need
a
printer table with a bottom feed slot.
Make sure the paper selection lever is set to the rear position.
Open the top cover.
From the bottom of the printer, insert the continuous papers.
Set the continuous
papers with the print side facing you.
Push
the
continuous papers upward from the bottom, then pull them up from the above.
Unlock the left and right tractors by flipping their lock levers up.
Open the left and right tractor covers.
Set the left and right tractors so that their feed pins align with the holes on the
left and right sides of the paper.
Close and lock the both tractors into position
by flipping the lock levers down.
NOTE: Fit the paper snugly between the tractors but do not stretch the paper feed holes.
Gently pull the continuous papers to remove the slack.
Close the top cover.
Turn on the printer power.
The printer is now ready to receive print commands from your computer.
NOTE:
When
the printer is out of paper during printing and the SELECT light is blinking,
insert continuous papers and press MODE to resume printing.
To Next Page
Loading...