50
Appendix B Paper Specifications
Table B-4 Print Area Dimensions for Tractor
Dimensions Description Measurements
Distance
from the left edge
to the first
print
position
30
mm (1.18 in.)
(when the left tractor is in the extreme
left
position).
Distance from the right edge to the last print position 30 mm (1.18 in.)
(when the right tractor is in the extreme right position).
Distance to the middle of the first print line. 23.6 mm (0.93 in
Usually a non-printing area because of nearness of
perforation. Adjustable by changing memory
switch
setting (see Section 3).
Distance to the bottom of the first print line. 25.4 mm (1 in.)
Usually a non-printing area because of
nearness
of 23.6 mm (0.93 in
.)
perforation. Next print fine after the paper is tom at
the perforation is factory-set to 0.93 inch. Adjustable
by changing memory switch setting (see Section 3).
Table
B-5
Print Area Dimensions for Envelopes
Dimensions Description
Measurements
AandB
Margins (Normally non-printing area)
12.7 mm (0.5 in.)
C Distance from the top edge to the
middle
of the first print line
23.6 mm (0.93 in.)
C
Distance from the top edge
to
the bottom of the first print line
25.4 mm (1 in.)
D
Distance from the bottom edge to the middle of the fast print line 27.1 mm (1.07 in.)
D
Distance from the bottom edge to the bottom of the fast print fine 25.4 mm (1 in.)
To Next Page
Loading...