NEC SL1000 - Page 120

Item
No.
Item Input Data Default
Related Program
Note
09 Private Line 0 = Disable Private
Line (Normal)
1 = Enable Private
Line (Private Line)
0
10 DTMF Tones for Outgoing
Calls
Use this option to enable (1) or
disable (0) DTMF tones for out-
going trunk calls.
0 = Disable (No)
1 = Enable (Yes)
1
11 Account Code Required 0 = Disable (No)
1 = Enable (Yes)
1
13 Trunk-to-Trunk Transfer
Use this option to enable (1) or
disable (0) loop supervision for
the trunk. This option is required
for Call Forwarding Off-Premise
and Tandem Trunking only.
0 = Disable (No)
1 = Enable (Yes)
0
14 Long Conversation Cutoff
Use this option to enable or dis-
able the Long Conversation Cut-
off feature for each trunk.
0 = Disable (No)
1 = Enable (Yes)
0 20-21-03
20-21-04
15 Long Conversation Alarm Be-
fore Cutoff
Use this option to enable or dis-
able the Long Conversation
Alarm for each trunk.
0 = Disable (No)
1 = Enable (Yes)
0 20-21-01
20-21-02
16 Forced Release of Held Call
Use this option to enable/disable
forced release for calls on Hold.
If enabled, the system discon-
nects a call if it is on Hold longer
than a programmed interval
(Program 24-01-05). If disabled,
forced disconnection does not
occur. Program 24-01-01 also
affects this option.
0 = Disable (No)
1 = Enable (Yes)
0 24-01-01
24-01-05
17 Trunk to Trunk Warning Tone
for Long Conversation Alarm
Use this option to enable or dis-
able the Warning Tone for Long
Conversation feature for DISA
callers.
0 = Disable (No)
1 = Enable (Yes)
0
18 Warning Beep Tone Signaling 0 = Disable (No)
1 = Enable (Yes)
0
19 Privacy Mode Toggle Option
Use this option to enable or dis-
able a trunk ability to be
switched from private to non-
private mode by pressing the
line key or Privacy Release func-
tion key.
0 = Disable (No)
1 = Enable (Yes)
0
20 Block Outgoing Caller ID
Allow (1) or prevent (0) the sys-
tem from automatically blocking
outgoing Caller ID information
when a user places a call. If al-
lowed (i.e. block, enabled), the
system automatically inserts the
Caller ID block code (defined in
14-01-21) before the user dialed
digits.
0 = Prevent (No)
1 = Allow (Yes)
0 14-01-21
20-08-15
ISSUE 1.0SL1000/SL1100
Program
14
Program 14 : Trunk, Basic Setup2-98