NEC SL1000 - Section 2 PROGRAMMING MODE; Entering the Programming Mode; Exiting the Programming Mode; Saving (Backup) the Customer Data

SECTION 2 PROGRAMMING MODE
2.1 Entering the Programming Mode
The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial #
*
#
*
.
Password
TUE18 7:27PM
200
Figure 3-6 Entering Programming Mode Display 1
3. Dial the system password, then press Hold key to enter the Program Mode.
Password @@@@@@@@
Program Mode
Figure 3-7 Entering Programming Mode Display 2
For the details of programming, refer to the SL Programming Manual. (separate issue)
2.2 Exiting the Programming Mode
1. Press Mute key several times to return to the "Program Mode" Screen.
10-01- Sys
Time&Data Setup Program Mode
Figure 3-8 Exiting the Programming Mode Display 1
2. Press Speaker key to exit.
Program Mode
TUE18 7:27PM
200
Figure 3-9 Exiting Programming Mode Display 2
The system automatically saves the customer data to the memory which is backed up by lithium
battery.
2.3 Saving (Backup) the Customer Data
When the installer/system administrator exits from the programming mode, the system will
automatically save the customer data to the on-board memory which is backed up by lithium battery.
Additionally, the customer data can be saved to a CF Card for backup purpose. The PZ-VM21
daughter board must be installed to the CPU card with a BLANK CF card inserted.
SL1000
ISSUE 3.0
3-4 System Start Up