NEC SL1000 - InMail - Sending Calls to Mailbox; Forward All Calls to Mailbox; Forward Calls When Busy; Forward Calls When No Answer

2.2.3 IP4WW-000E-A1
This is an expansion card for mounting 2BRIDB board, and
is installed into 1632M KSU/1632ME EXP.
• Install this card to the expansion card slot at Main/
Expansion KSU
• One ISDN BRI daughter board connection
2.2.4 IP4WW-2BRIDB-C1
The 2BRIDB provides two ISDN (Basic Rate) circuit and is
mounted on the 008E or 000E card. A total of nine 2BRIDBs
can be installed per system or three 2BRIDBs per KSU.
• Mount this board onto the 008E or 000E card.
• Supports T/S point connection (Hard-switch).
• All ISDN circuits are not supplied with DC power from the
system.
2.2.5 IP4WW-1PRIU-C1
The 1PRIU is installed in the 1632M KSU or 1632ME EXP
providing for either an ISDN Primary Rate Interface, T1
Interface or E1 interface. A total of three 1PRIUs can be
installed per system or one 1PRIU per KSU.
• Install this card to the expansion card slot at Main/
Expansion KSU.
• Supports T/S point connection (Hard-switch).
2.3 Optional Interface Cards
2.3.1 IP4[ ]-MEMDB-C1
This card provides additional expansion memory. Following memories are equipped on this card.
Table 1-1 Memory Capacity of MEMDB-C1
Memory Type
Capacity
SDRAM 64 MB
Flash Memory 32 MB
SL1000 ISSUE 3.0
1-6 Introduction