NEC SL1000 - Figure 2-6 Screw Positions; Figure 2-7 Sub-Cover Slide-Out

2. Install four screws into the wall. The screw heads must stand off from the wall about 2.5 mm
(0.098″) to 3.5 mm (0.138″).
285 mm (11.221)
285 mm (11.221)
180 mm
(7.087)
2.5 mm (0.098) -
3.5 mm (0.138)
Figure 2-6 Screw Positions
• Wall-Mounting Screws (M4.1x 25: 4 pcs) are attached to the KSU.
• The screw diameter is 4 mm (0.158″) to 4.5 mm (0.177″).
3. Push the center of the Sub-Cover and slide it outward.
Sub-Cover
Figure 2-7 Sub-Cover Slide-out
ISSUE 3.0 SL1000
Hardware Manual 2-7