NEC SL1000 - Installing the Expansion KSU(S); General; Unpacking (EXIFB-C1); Connectors Location (EXIFB-C1)

1.4 Installing the Expansion KSU(s)
1.4.1 General
Each Expansion KSU is connected to the Main KSU individually. The EXIFB-C1 card and the
MEMDB-C1 card must be installed in the Main
KSU (1632M-A) . (Refer to Installing the Expansion
Memory Card (MEMDB-C1) on page 2-60 for MEMDB-C1 card)
1.4.2 Unpacking (EXIFB-C1)
Unpack the EXIFB-C1 and check it against physical damage.
Table 2-3 EXIFB-C1 Packing List
Items List of Contents QTY
EXIFB-C1 EXIFB-C1 PCB 1
1.4.3 Connectors Location (EXIFB-C1)
J4
J6J5
J1
J2
J3
Figure 2-11 Connectors of EXIFB-C1
Table 2-4 Connectors of EXIFB-C1
No. Connectors Connectable Devices
J1 Expansion Connector Expansion KSU 3
J2 Expansion Connector Expansion KSU 2
J3 Expansion Connector Expansion KSU 1
J4 Mother PCB J1 connector on 408M-A1
J5, J6 Debug Purpose (Not used) -
1.4.4 Installing the EXIFB-C1 PCB
Do Not Power on until all installations have been completed.
1. Turn off the system power and disconnect the AC cord from KSU.
ISSUE 3.0
SL1000
Hardware Manual 2-9