NEC SL1000 - Cabling and Setting the Expansion Interface Card; Figure 2-73 Mounting the 2 BRIDB-C1 into the KSU; Figure 2-74 Replacing the Main-Cover

5. Mount the 2BRIDB-C1 with 008E-A1/000E-A1 PCB into the KSU.
008E-A1/000E-A1 PCB
and 2BRIDB-C1 PCB
Nylon-
Spacers
J1
Metal-Spacers
J2
Screws
Figure 2-73 Mounting the 2BRIDB-C1 into the KSU
6. Replace the Main-Cover and fasten two screws.
Two screws
Hooks
Main-Cover
Figure 2-74 Replacing the Main-Cover
3.4 Cabling and Setting the Expansion Interface Card
Precautions for Cabling
• Do not wire the cable with an AC cable, computer, etc.
• Do not run the cable near the high frequency generating device.
ISSUE 3.0
SL1000
Hardware Manual 2-49