NEC SL1000 - Page 750

7. Press Hold and Enter the Ringing Destination (13-04-04).
If you Select TRF1 ~3 following can be entered/
TRF1 (Internal Dial): Up to 36 digits
TRF2 (Incoming ring Group): 0-25
TRF3 (Remote Monitor): Dial Up to 4 digits (SL1000) 8 digits (SL1100).
If you press Exit Key you can clear the digits you entered.
ABB0001 MXTarget
MX = X is Mode 1 ~ 3 (13-04-03) (SL1000)
ABB0005 ModeX Target
ModeX= X is Mode 1 ~ 3 (13-04-03)
(This display indication is for IP Terminal Only.) (V2.0 or higher) (SL1000)
(This display indication is for IP and Multiline Terminals.) (SL1100)
8. Press Hold and you enter the Incoming Ring Pattern (13-04-05).
0 ~ 9 can be entered and 0 ~ 9 are followings:
0 = Normal pattern
1-4 = Tone pattern (1-4)
5-9 = Scale pattern (1-5)
ABB0001 ModeX
Ring (0-9)? 1-
MX = X is Mode 1 ~ 3 (PRG 13-04-03) (SL1000)
ABB0005 ModeX
Ring(0-9)?1-
ModeX = X is Mode 1 ~ 3 (PRG 13-04-03)
(This display indication is for IP Terminal Only.) (V2.0 or higher) (SL1000)
(This display indication is for IP and Multiline Terminals.) (SL1100)
SL1000/SL1100 ISSUE 2.0
1-740
Voice/Melody Ringing by VM
V