System Availability
Terminals
All Terminals
Required Component(s)
None
Related Features
Abbreviated Dialing/Speed Dial
Automatic Route Selection (ARS/F-Route)
One-Touch Calling
PBX Compatibility/Behind PBX
Station Message Detail Recording
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
Number
Program Name/Description Assigned Data
14-01-11 Basic Trunk Data Setup - Account Code Required
Per trunk enable or disable the ability to enter an account code on an
inbound or outbound trunk call.
0 = Disabled (user cannot enter ac-
count codes using this trunk.)
1 = Enabled (user can enter account
codes using this trunk.)
(default = 1)
35-05-01 * Account Code Mode
Per class of service (PRG 20-06-01) this program is used to setup the
account code mode.
For the Account Code Entry feature, setting (1) will be the setting that
is used.
0 = Account Codes Disabled
1 = Account Codes Optional (This
is for the account code entry feature.)
2 = Account Code Required Not
Verified (Forced Account Codes ena-
bled, no verification with the system
required)
3 = Account Code Required and
Verified (Forced Account Codes ena-
bled, verification with PRG 35-06-01
required)
(default = 0)
35-05-03 Account Codes for Incoming Calls
Per class of service (PRG 20-06-01) this program is used to allow or
deny users the ability to enter an account code for incoming calls.
Account codes for incoming calls are used in conjunction with SMDR
for billing purposes.
0 = Disabled (User cannot enter an
account code.)
1 = Enabled (User can enter an ac-
count code while on an incoming
call.)
(default = 0)
ISSUE 2.0 SL1100
Features and Specifications Manual 1-19
A
To Next Page
Loading...
