NEC SL1100 - Page 318

Program Num-
ber
Program Name
Default
20-02-05 System Options for Multiline Telephones - Headset Busy
Mode
0
20-02-12 System Options for Multiline Telephones - Forced Inter-
com Ring (ICM Call Type)
1
20-09-07 Class of Service Options (Incoming Call Service) - Call
Queuing
COS 01~15 = 1
20-13-06 Class of Service Options (Supplementary Service) - Auto-
matic Off-Hook Signaling (Automatic Override)
Refer to Programming Manual.
Operation
To enable the headset:
1. Plug in the headset into the headset jack on the bottom of the telephone.
2. Program a Headset key (PRG 15-07 or SC 751: 05).
You hear a confirmation beep.
To use the headset:
The Headset key lights when on a call. To disconnect, press the Headset key again.
You can still use the handset for calls or respond to voice-announced Intercom calls with the headset
plugged in. The headset only activates when the Headset key is pressed.
1. Answer a ringing call by pressing the Headset key.
- OR -
2. Press the Headset key and then a line key or press Speaker key then 9 to make a outgoing call.
- OR -
3. Press the Headset key to get intercom dial tone.
- OR -
4. If on a call, press the Headset key to hang up.
SL1100 ISSUE 2.0
1-306
Headset Operation
H