NEC SL1100 - Page 530

2. Dial the extension number assigned to the Mobile Extension.
If the Mobile Extension is turned off, incoming calls hear a message indicating the user is not
available. The setting in the DTMF Confirmation programming (PRG 15-22-02) determines how
the call is handled.
PRG 15-22-02 set to 0 or 1 (DTMF Confirmation Required):
The caller is retrieved by the SL1100 and follows the no-answer programming (ring another
extensions, forward to SL1100 voice mail, etc.)
PRG 15-22-02 set to 2 (No DTMF Confirmation Required):
The caller is forwarded to the external extension voice mail, if available.
Outside Party Dialing the Mobile Extension:
1. Dial the DID or DIL telephone number for the Mobile Extension.
2. System programming (DID=22-11-01 or DIL=22-07-01) must be defined.
If the Mobile Extension is turned off, incoming callers hear a message indicating the user is not
available. The setting in the DTMF Confirmation programming (PRG 15-22-02) determines how
the call is handled.
PRG 15-22-02 set to 0 or 1 (DTMF Confirmation Required):
The caller is retrieved by the SL1100 and follows the no-answer programming (ring another
extension, forward to SL1100 voice mail, etc.)
PRG 15-22-02 set to 2 (No DTMF Confirmation Required):
The caller is forwarded to the external extension voice mail, if available.
Placing a Call from the Mobile Extension:
1. Dial the DID or DIL telephone number for the Mobile Extension.
If the Caller ID of the Mobile Extension matches the Speed Dial bin entry (PRG 13-04 and PRG
15-22), internal dial tone is heard by the Mobile Extension user.
2. Dial the desired Intercom number or dial the trunk access code to place an outgoing call.
Answering a Call on the Mobile Extension:
1. Answer the ringing call.
2. If PRG 15-22-02 is set to 0 or 1, the Mobile Extension user hears Music on Hold/ring tone. Press
*
(within 10 seconds) to answer the call.
This step is required when using analog trunks for the Mobile Extension feature.
Sending a Flash from the Mobile Extension:
1. While on a conversation, a hook flash is returned by dialing
*
# from the Mobile Extension.
Internal Dial Tone After Hang Up:
1. When a call is finished, disconnect the call and receive internal dial tone by dialing
*
0.
Placing/Retrieving a Call on Hold from the Mobile Extension:
1. While on a call, dial
*
#.
2. To retrieve the held call, with system dial tone, dial
*
#.
SL1100
ISSUE 2.0
1-518
Mobile Extension
M